SV: [fairchildclub] warner 165

Jp Lorie · Post by **Jp Lorie** » Mon May 09, 2011 9:49 am

'Does anyone know if the rubber hose that connects the push-rod tubes to the
engine case can be replaced without pulling the cylinders off.

JP.Lorie
Florida

[Non-text portions of this message have been removed]'

paul pinato · Post by **paul pinato** » Mon May 09, 2011 10:22 am

'Hi

You have to unscrew the pushrod tube from the
cylinder. On my engine it was very close. The
pushrod tube can be hard to unscrew as the grip is
so thin. It cost me two knuckles.

Paul

UC61A

SE-AWS

Från: fairchildclub@yahoogroups.com
[mailto:fairchildclub@yahoogroups.com] För Jp
Lorie
Skickat: den 9 maj 2011 17:49
Till: fairchildclub@yahoogroups.com
Ämne: [fairchildclub] warner 165

Does anyone know if the rubber hose that connects
the push-rod tubes to the
engine case can be replaced without pulling the
cylinders off.

JP.Lorie
Florida

[Non-text portions of this message have been
removed]

[Non-text portions of this message have been removed]'