Re: 24W41 or later parts needed

An archive of all the messages posted in the old Fairchild Club Yahoo Group. It is not possible to start a new topic in this forum (please use one of the other forums for new threads), but you can continue to post on existing topics.
Post Reply
Alan Macon
Posts: 33
Joined: Tue Dec 16, 2003 1:51 am

24W41 or later parts needed

Post by Alan Macon »

'WANTED ? I am looking for a set of steps , Gear legs prefer with tie
down rings "Export" but not required, Rear aluminum lift strut
preferred steel will work or a project with these parts, Send me a
picture of what you have or drop me a call , Wenatchee, WA
Telephone: 509 679-0721
Have a good day'
Bob Etter
Posts: 48
Joined: Fri Sep 07, 2007 9:01 pm

Re: 24W41 or later parts needed

Post by Bob Etter »

'Just in case you didn't know. Those case rings that are located on the lower front of the main gear legs, are for towing....only. A gentleman that I know, used them for tie-downs. That was the last time that the airplane flew. I had heard that some one was attempting to repair it. All 4 spars were broken, and the top of the cabin had been crushed about 4 inchs. The metal parts that is.

A high wind hit the front of the airplane causing the main struts to extend fully. This imparted a large increase in the angle of attack to the unmanned airplane. Both rings snapped off in a heart beat, and over she went.
Bob
----- Original Message -----
From: Alan Macon
To: fairchildclub@yahoogroups.com
Sent: Sunday, March 09, 2008 9:54 AM
Subject: [fairchildclub] 24W41 or later parts needed


WANTED . I am looking for a set of steps , Gear legs prefer with tie
down rings "Export" but not required, Rear aluminum lift strut
preferred steel will work or a project with these parts, Send me a
picture of what you have or drop me a call , Wenatchee, WA
Telephone: 509 679-0721
Have a good day





[Non-text portions of this message have been removed]
'
Alan Macon
Posts: 33
Joined: Tue Dec 16, 2003 1:51 am

Re: 24W41 or later parts needed

Post by Alan Macon »

'--- In fairchildclub@yahoogroups.com, "Bob Etter" wrote:
>
> Just in case you didn't know. Those case rings that are located on
the lower front of the main gear legs, are for towing....only. A
gentleman that I know, used them for tie-downs. That was the last
time that the airplane flew. I had heard that some one was
attempting to repair it. All 4 spars were broken, and the top of the
cabin had been crushed about 4 inchs. The metal parts that is.
>
> A high wind hit the front of the airplane causing the main struts
to extend fully. This imparted a large increase in the angle of
attack to the unmanned airplane. Both rings snapped off in a heart
beat, and over she went.
> Bob
>
> ----- Original Message -----
> From: Alan Macon
> To: fairchildclub@yahoogroups.com
> Sent: Sunday, March 09, 2008 9:54 AM
> Subject: [fairchildclub] 24W41 or later parts needed
>
>
> WANTED . I am looking for a set of steps , Gear legs prefer with
tie
> down rings "Export" but not required, Rear aluminum lift strut
> preferred steel will work or a project with these parts, Send me
a
> picture of what you have or drop me a call , Wenatchee, WA
> Telephone: 509 679-0721
> Have a good day
>
>
>
> Thanks Bob
I also think they were also installed on export aircraft.I
> have a right gear . They can be seen in the photo section.
Thanks Alan Macon
> [Non-text portions of this message have been removed]
>
'
Post Reply