Fairchild Club Forum

'Does anyone happen to have a legible set of detailed drawings for the fuselage bulkheads that are correct for an F24 R46 (UC61K) - specifically the 'belly' ones.

My old bulkheads ( replacements ) are a figment of someone's imagination - not even symetrical about the centreline.

I am having ...

'John,

I would be grateful for the same info - my senders and gauges have been with
a guy that said he could rewind the senders for a year and a half - so I'm
not too hopeful at present.

Progress has been very slow of late - work is getting in the way!

Many thanks indeed

Frank Cox ...

'To all who responded,

Thanks very much for your time and handy tips.

I have cut mine in half - puzzle is now resolved - I have made the whole floor from 3/16 " Fibrelam - a suitable piece somehow came my way! - should save a little weight which was the original objective of the rebuild ...

'Jamie,

Many thanks - I thought that might be the case - there is just not any other
way to get it to fit.

Frank


----- Original Message -----
From: "Jamie Treat"
To:
Sent: Saturday, May 01, 2004 5:29 PM
Subject: Re: [fairchildclub] F24R46 Cockpit floor


> Frank,
>
> My 24R46 ...

'Folks,

I have built a new Centre Floor (under the pilots'seats) as per drawing 41484 on the CD ROM as one piece - the drawing is not that clear and I can not see any thing that indicates it is other than one piece.

The old floor was cut into 2 halves and was a piece of cake to put in and take ...

'Hunting for information again I,m afraid.

Does anyone have a source or knowledge of a modern eqivalent for the A151 pulleys in the forward rudder cable run as specified in the parts manual.

Mine are very worn and need replacing.

Many thanks

Frank Cox



[Non-text portions of this ...

'Hunting for information again I,m afraid.

Does anyone have a source or knowledge of a modern eqivalent for the A151 pulleys in the forward rudder cable run as specified in the parts manual.

Mine are very worn and need replacing.

Many thanks

Frank Cox


[Non-text portions of this ...

'Does any one have the specs for the bearings at the ends of the rudder torque tubes - 4 off (make and Pt. No. if possible)?

I can't find them in any drawing and I have temporarily misplaced the old ones - been at the job for over 10 years! and only just got back to it after a year with other ...

'Bob,

Many thanks for your reply,

Yes, I have come to the same conclusion.

I am now on my second door and am building it in the frame using the hinges
as the starting point. and allowing 1/8" clearance all round- a bit
tricky -especially with the mating at the corners. after that it is ...

'Can anyone help?

I am rebuilding the cabin doors and for reference it would be good to check the drawings as the present doors are well past their sell by date and have been poorly repaired in the past so I am not entirely sure if the dimensions are correct.

Unfortunately the drawings on the ...