Fairchild Club Forum

I am new to the forum, but have been a club member for many years. I am restoring a 1937 F24H model Fairchild and I need information on the trim cable guide attached near the vertical stab forward attach fitting. My best guess is part number 40193 "Lug, Cable Guide Tab". This part was used...

'Also not a fan of Facebook. It's a lot like "Constant Contact', which should be called "Constant Annoyance" in my humble opinion. https://ec.yimg.com/ec?url=https%3A%2F%2Fipmcdn.avast.com%2Fimages%2Ficons%2Ficon-envelope-tick-round-orange-animated-no-repeat-v1.gif&t=1571701293&am...

'I fabricated a new tail wheel oleo for my 1937 Fairchild F24H from the original oleo parts, but the original tailwheel Piston Tube Assembly portion, P/N 43149 was damaged and I could not determine the piston tube length dimension from it. There are no prints for these early tailwheel parts at the N...

'The drawing number 43208 identifies that dimension as 10 3/8 inches to hole center. Virus-free. www.avast.com On Wed, Oct 2, 2019 at 8:44 AM Ji?í Horák jerry.fly@seznam.cz [fairchildclub] wrote: > > > Gents, > > I need a help in following thing. > > Would you tell me length of the UC 61K Tailwheel ...

'Emil, I have several NOS Ranger mag drive couplings, but all are dried up and hard. If you can find a technical drawing for them, you may be better off having new ones manufactured.I know I would be interested in fresh couplings.  https://ec.yimg.com/ec?url=https%3A%2F%2Fipmcdn.avast.com%2Fimages%2...

'I purchased a project with a scrapped F24 H fuselage that was powder coated, and the paint looks great, but be careful. Have the sand blasted structure carefully inspected and repaired as needed before the powder coating is applied.  That coating is very thick, very difficult to remove and can not ...

'I had the same mechanical brake setup on my 1937 F24-H model. The grease seal was felt, but leather should work just fine. That seal does not require a precision fit. A tight fitting seal of that kind will wear in to a proper fit in short time.  Sorry I don't have a part number for you. On Mon, Nov...

'If you are looking for old cylinders that are worn over .020" and usable for display only, I have many of these and I am located in southern CA. You can have them for the shipping charges.ThanksRich Seifert714-356-6950 On Mon, Oct 22, 2018 at 8:04 PM cmueller@csuchico.edu [fairchildclub] wrote...

'Try Fresno Air Parts. They had everything I needed for a Stromberg NA-S3, and my NA-R4B carbs.Phone 559-237-4863 On Sat, Sep 29, 2018, 10:27 PM Dave Greig ozzyfairchild@yahoo.com [fairchildclub] wrote:   Hi,I’m looking for a stainless steel needle and seat for the NAR4B carb.Can anyone help with in...

'Ranger Exhaust Gaskets.Fresno Air Parts has them.520 W. Kearney Blvd.Fresno, CA. 93706-2598559-237-4863 On Sat, Sep 22, 2018 at 7:46 AM David Carrick dcarrick@ch2a.ca [fairchildclub] wrote:   Does anyone know where I might be able to pick up a set of 6 ranger exhaust gaskets?.. Or is this something...