Re: Ranger Crankshaft plug repair

[John Ellis]

'Hi all,

I think i remember reading that someone has a CNC program to groove these plugs for an o'ring.

Would like to contact them for more information.

contact me at : johnee35@att.net

Thanks, John

[Non-text portions of this message have been removed]'

[WILLIAM SPRIGGS]

'John: I have a manual jig for grooving the sludge plugs for an o-ring. It works in a vertical mill and is done by hand. Seems to work okay, we have put them in one Ranger, but still working on the PT19 so have not run it yet. We are running one Ranger without the plugs so will have a comparison. Give me a call and can tell you more. Bill Spriggs 805 657-2460. waspriggs@msn.com



To: fchld@bevcomm.net; fairchildclub@yahoogroups.com
From: johnee35@att.net
Date: Sat, 21 Nov 2009 10:37:07 -0600
Subject: [fairchildclub] Ranger Crankshaft plug repair





Hi all,

I think i remember reading that someone has a CNC program to groove these plugs for an o'ring.

Would like to contact them for more information.

contact me at : johnee35@att.net

Thanks, John

[Non-text portions of this message have been removed]






[Non-text portions of this message have been removed]'