Page 1 of 1
PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
Posted: Mon May 14, 2012 7:16 am
by ClairC
'Need a source for the copper crush gaskets that seal the oil screens on a PT-19, 200 hp, Ranger engine
There are two:
a large one where the spring is enclosed, higher on the engine.
a small one lower on the engine.
Any suggestion would be appreciated
Thankx'
Re: PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
Posted: Mon May 14, 2012 7:56 am
by Seifert
'Fresno Air Parts has them. 559-237-4863. You might have to buy the gasket kit which contains them all at $98 dollars.
----- Original Message -----
From: ClairC
To:
fairchildclub@yahoogroups.com
Sent: Monday, May 14, 2012 6:16 AM
Subject: [fairchildclub] PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
Need a source for the copper crush gaskets that seal the oil screens on a PT-19, 200 hp, Ranger engine
There are two:
a large one where the spring is enclosed, higher on the engine.
a small one lower on the engine.
Any suggestion would be appreciated
Thankx
[Non-text portions of this message have been removed]
'
Re: PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
Posted: Mon May 14, 2012 8:25 am
by Tom_Downey
'Aren't they the typical AN-900 gasket? measure the size and order from Aircraft Spruce and Speciality
--- In
fairchildclub@yahoogroups.com, "Richard Seifert" wrote:
>
> Fresno Air Parts has them. 559-237-4863. You might have to buy the gasket kit which contains them all at $98 dollars.
> ----- Original Message -----
> From: ClairC
> To:
fairchildclub@yahoogroups.com
> Sent: Monday, May 14, 2012 6:16 AM
> Subject: [fairchildclub] PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
>
>
>
> Need a source for the copper crush gaskets that seal the oil screens on a PT-19, 200 hp, Ranger engine
>
> There are two:
>
> a large one where the spring is enclosed, higher on the engine.
>
> a small one lower on the engine.
>
> Any suggestion would be appreciated
>
> Thankx
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
'
Re: PT-19 RANGER L-440 COPPER OIL SCREEN CRUSH GASKETS
Posted: Mon May 14, 2012 8:28 am
by ccmueller001
'I just got some of the larger 2 1/8" ID crush gaskets from Fresno Airparts. Phone 559 237 4863. Offer to send them a check ahead of time or they will be shipped COD by UPS for an additional $20. They cost about $8 each.
Charles
--- In
fairchildclub@yahoogroups.com, "ClairC" wrote:
>
> Need a source for the copper crush gaskets that seal the oil screens on a PT-19, 200 hp, Ranger engine
>
> There are two:
>
> a large one where the spring is enclosed, higher on the engine.
>
> a small one lower on the engine.
>
> Any suggestion would be appreciated
>
> Thankx
>
'