Fairchild Club Forum

----- Original Message -----
From:
To:
Sent: Thursday, March 22, 2001 10:09 PM
Subject: [fairchildclub] Re: Fairchild Moonglo Lustlights


> --- In fairchildclub@y..., jstreat360@a... wrote:
> > Dan,
> >
> > I am lucky and have two in my F-24. MoonGlow is the correct name.
> Steve Hamilton questioned me a few weeks ago. He remembered my 24 had
> them, sent a photo. He is also looking for a set. Steve and I are
> also looking for a new/old source for the Anti Skid material that
> goes onto the Wheel Fenders, lift stuts, door sills and rudder
> pedals. There appears to be three patterns that were used. Most
> common was the Diamond pattern. Will pass on any info if we locate.
> >
> > Jamie Treat
> > ARR
>
>
>
> Jamie,
> Check restoration supply co. in Reno, NV for a pyramid style alum
> sheeting. They have a spot on match to the stuff on my rudder pedals.
> not cheap tho, seems Pierce Arrows and other elaborately expensive
> cars have the same material on the running boards.
> Are you sure that jasco alt is stc'd for ranger? My skytronics lit.
> says that it's stc'd for a Grumman G164. Last time I checked that was
> an agcat a widgeon is G144. It works any how as I know of 3 on 24's
> that were approved and flying.
> Just some ideas!
>
>
>
> To unsubscribe from this group, send an email to:
> fairchildclub-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

----- Original Message -----
From: Thekortas@aol.com
To: fairchildclub@yahoogroups.com
Sent: Saturday, March 24, 2001 7:21 AM
Subject: Re: [fairchildclub] Re: Fairchild Moonglo Lustlights


Hi Walt. You're right, but, just a little further clarification for those
new to this topic. Yes, the Jasco Alt. is STC'd for the 440 series Ranger.
However, the STC does NOT apply to Ranger installations in Fairchild
Aircraft. As you correctly point out, installation of the Jasco on a Ranger
in a Fairchild requires that it be done on a 337. I found that it was a VERY
nice conversion when I did mine in the F24R46A. I'll start work on a PT-26
soon and will give it serious consideration when she's finished up and flying
again.
Regards,
Steve Korta

Yahoo! Groups Sponsor




To unsubscribe from this group, send an email to:
fairchildclub-unsubscribe@yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]