Fairchild Club Forum

Looking for a #6300 exhaust flange. Doesn't need to be airworthy, just complete and in reasonable condition. Need it for measurements to fabricate at least 24 for my AT project. The V770 used modified 6300's and I need one to do the print to machine them. I have the print that modifies them, but several dimensions from the base part are not there.

Craig
AT-21-BL
42-48053

Are L-440 flanges same? I have a pair of exhaust stacks laying around and one has big hole in it, but flange is intact. The flanges are slightly thicker than replacements I found

I think they are. I'll have to pull the 6 cyl book to verify.

I screwed up and somehow when I did this post the first time, it said that it was successfully reported...