Page 1 of 1
Drawings for lightining holes in ribs.
Posted: Tue Jan 03, 2017 6:28 pm
by Michael Kelly
'
Craig:
I looked at the drawings on the PT metal controls and there isn't any dimensions for the holes. Just that the flange of the hole is at 60 degree.
Keep 'Em Flying!
Mike Kelly
FaIrchild Club
'
Re: Drawings for lightining holes in ribs.
Posted: Thu Jan 05, 2017 12:55 pm
by Craig
'
Thanks Mike, I was hoping that Fairchild had done like every other manufacturer and had done standards drawings for common items like the holes. I guess I'm going to have to crawl the film to see of the AT has any, or if not, come up with a table of dimensions. What's even rougher, is that if they carried the 60 deg angle to the AT, that means I'll have to have a set of dies made up......arrgghhh.....
Craig
On 01/03/2017 06:28 PM, Michael Kelly
hotfoot49@hotmail.com [fairchildclub] wrote:
Craig:
I looked at the drawings on the PT metal controls and there isn't any dimensions for the holes. Just that the flange of the hole is at 60 degree.
Keep 'Em Flying!
Mike Kelly
FaIrchild Club
'