Fairchild Club Forum

Posted: **Fri Dec 03, 2010 9:33 pm**

'New manufactured 3-1 exhaust has been fabricated and shipped. Will report fit/quality of this exhaust following installation. Also will compile learnings during process.
Would someone kindly inform me of the proper torque sequence and values for my new exhaust. New copper-clad gaskets, three into one system. Installation on '40 Fairchild 24R.
Bill C.'

Posted: **Sat Dec 11, 2010 8:36 pm**

'The AWI tubualr exhaust for my Ranger was installed without any problems or issues this week. Quality and fit are top notch! I anticipated having to file/fit the exhaust to the studs, but they slid right on without any bind.

The fab work is excellent, and I would highly recommend AWI/AMI in MN to our Club.

Bill C.

--- In fairchildclub@yahoogroups.com, "Bill" wrote:
>
> New manufactured 3-1 exhaust has been fabricated and shipped. Will report fit/quality of this exhaust following installation. Also will compile learnings during process.
> Would someone kindly inform me of the proper torque sequence and values for my new exhaust. New copper-clad gaskets, three into one system. Installation on '40 Fairchild 24R.
> Bill C.
>

'

Fairchild Club Forum

Re: Exhaust Gasket Torque Range

Fairchild Exhaust Gasket Torque Range

Re: Exhaust Gasket Torque Range