Page 1 of 1
Ranger Crankshaft plug repair
Posted: Sat Nov 21, 2009 10:37 am
by John Ellis
'Hi all,
I think i remember reading that someone has a CNC program to groove these plugs for an o'ring.
Would like to contact them for more information.
contact me at :
johnee35@att.net
Thanks, John
[Non-text portions of this message have been removed]'
Re: Ranger Crankshaft plug repair
Posted: Sun Nov 22, 2009 11:17 am
by WILLIAM SPRIGGS
'John: I have a manual jig for grooving the sludge plugs for an o-ring. It works in a vertical mill and is done by hand. Seems to work okay, we have put them in one Ranger, but still working on the PT19 so have not run it yet. We are running one Ranger without the plugs so will have a comparison. Give me a call and can tell you more. Bill Spriggs 805 657-2460.
waspriggs@msn.com
To:
fchld@bevcomm.net;
fairchildclub@yahoogroups.com
From:
johnee35@att.net
Date: Sat, 21 Nov 2009 10:37:07 -0600
Subject: [fairchildclub] Ranger Crankshaft plug repair
Hi all,
I think i remember reading that someone has a CNC program to groove these plugs for an o'ring.
Would like to contact them for more information.
contact me at :
johnee35@att.net
Thanks, John
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]'