Page 1 of 1

Video Posted

Posted: Mon Jan 05, 2009 9:46 am
by flyingbanks
'Just wanted to let everyone know that I have the first video of my F24
posted on Youtube. The video is the second engine start after I
purchased the airplane and moved it to GA. The Engine had not been run
in about 18 months prior to the first start which was the week prior to
this start. I have a video for it as well but it was dark and raining
so the quality is not as good. I hope to post a series of videos over
the next few months as I complete the reassembly and annual of the 24
and get her back in the air. Hope you enjoy!

http://www.youtube.com/watch?v=BrNbSLu8bBQ

Matt'

Re: Video Posted

Posted: Mon Jan 05, 2009 12:06 pm
by Tom Downey
'--- In fairchildclub@yahoogroups.com, "flyingbanks"
wrote:
Just wanted to let everyone know that I have the first video of my
F24 posted on Youtube.

That sounds great.. looks like a flyer to me.'

Re: Video Posted

Posted: Sun Jan 11, 2009 11:34 am
by Bob Etter
'Thanks for the check. I really didn't keep track of everything, but I think it is close.

I tried to look at the video, but I've got a land line telephone connection. I can get 3 seconds of picture every 1-1.5 minutes of on line time. I'll try it again later when I've got access to a faster connection.

Thanks,
Bob
----- Original Message -----
From: flyingbanks
To: fairchildclub@yahoogroups.com
Sent: Monday, January 05, 2009 7:46 AM
Subject: [fairchildclub] Video Posted


Just wanted to let everyone know that I have the first video of my F24
posted on Youtube. The video is the second engine start after I
purchased the airplane and moved it to GA. The Engine had not been run
in about 18 months prior to the first start which was the week prior to
this start. I have a video for it as well but it was dark and raining
so the quality is not as good. I hope to post a series of videos over
the next few months as I complete the reassembly and annual of the 24
and get her back in the air. Hope you enjoy!

http://www.youtube.com/watch?v=BrNbSLu8bBQ

Matt





[Non-text portions of this message have been removed]
'