Page 1 of 1
Vertical Stab
Posted: Wed Apr 09, 2008 10:37 am
by ROBERT COON
'We're in the finishing processes of scratch building our vertical stab and have run into two schools of thought regarding finishes. One is to varnish and paint over the plywood; two is to cover over the plywood with fabric (polyfibre). I would prefer the latter but would wonder about the airfoil spine that runs the whole length of the vertical. Does that get covered, as well. Any answers would be greatly appreciated.
Bob Coon
Jim Chybicki
UC-61, HB690
"Keep em' flyin".
[Non-text portions of this message have been removed]'
Re: Vertical Stab
Posted: Wed Apr 09, 2008 1:34 pm
by John Ellis
'I am working on a vertical stab. and center section for a PT-19.
I used two part epoxy varnish on the new wood, then covered with ceconite.
Use the 1.7 oz ( non-certified ). It is legal for covering wood, and works some easier than the 2.8 and 3.7.
Have fun,
John
----- Original Message -----
From: ROBERT COON
To: fairchild fairchild
Sent: Wednesday, April 09, 2008 11:37 AM
Subject: [fairchildclub] Vertical Stab
We're in the finishing processes of scratch building our vertical stab and have run into two schools of thought regarding finishes. One is to varnish and paint over the plywood; two is to cover over the plywood with fabric (polyfibre). I would prefer the latter but would wonder about the airfoil spine that runs the whole length of the vertical. Does that get covered, as well. Any answers would be greatly appreciated.
Bob Coon
Jim Chybicki
UC-61, HB690
"Keep em' flyin".
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
'
Re: Vertical Stab
Posted: Thu Apr 10, 2008 8:59 am
by ROBERT COON
'John,
Thanks for the information. We'll start this weekend.
Regards,
Bob
John Ellis wrote:
I am working on a vertical stab. and center section for a PT-19.
I used two part epoxy varnish on the new wood, then covered with ceconite.
Use the 1.7 oz ( non-certified ). It is legal for covering wood, and works some easier than the 2.8 and 3.7.
Have fun,
John
----- Original Message -----
From: ROBERT COON
To: fairchild fairchild
Sent: Wednesday, April 09, 2008 11:37 AM
Subject: [fairchildclub] Vertical Stab
We're in the finishing processes of scratch building our vertical stab and have run into two schools of thought regarding finishes. One is to varnish and paint over the plywood; two is to cover over the plywood with fabric (polyfibre). I would prefer the latter but would wonder about the airfoil spine that runs the whole length of the vertical. Does that get covered, as well. Any answers would be greatly appreciated.
Bob Coon
Jim Chybicki
UC-61, HB690
"Keep em' flyin".
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
'