Fairchild Club Forum

Posted: **Tue May 11, 2004 10:21 am**

'Need a set of wings for a 38 f24j.'

Posted: **Wed May 12, 2004 6:01 am**

'Keith,

There are no wings that I know of available. Wing from other years will
fit.Fairchild did no make allot of changes.
you may have to get a degree in wing construction

John Berendt

----- Original Message -----
From: "Keith"
To:
Sent: Tuesday, May 11, 2004 11:20 AM
Subject: [fairchildclub] Wings needed

> Need a set of wings for a 38 f24j.
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>

'

Posted: **Wed May 12, 2004 12:21 pm**

'

> Keith,
>
> There are no wings that I know of available. Wing from other years

will

> fit.Fairchild did no make allot of changes.
> you may have to get a degree in wing construction
>
> John Berendt
> ----- Original Message -----
> From: "Keith"
> To:
> Sent: Tuesday, May 11, 2004 11:20 AM
> Subject: [fairchildclub] Wings needed
>
>
> > Need a set of wings for a 38 f24j.

I have offered to manufacturer wings, but I have had no offers. My
wings are off and stripped. It would be an easy do to reverse
engineer the patterns plus all the blue prints will be a great help.

Any one got an idea what the cost should be?

If any one has the iron parts that would be even better.'

Posted: **Wed May 12, 2004 8:32 pm**

'I have all the metal parts for a left wing, with flaps, for an F-24
airplane. norbymac20@earthlink.net

----- Original Message -----
From: "Tom Downey"
To:
Sent: Wednesday, May 12, 2004 1:21 PM
Subject: [fairchildclub] Re: Wings needed

> > Keith,
> >
> > There are no wings that I know of available. Wing from other years
> will
> > fit.Fairchild did no make allot of changes.
> > you may have to get a degree in wing construction
> >
> > John Berendt
> > ----- Original Message -----
> > From: "Keith"
> > To:
> > Sent: Tuesday, May 11, 2004 11:20 AM
> > Subject: [fairchildclub] Wings needed
> >
> >
> > > Need a set of wings for a 38 f24j.
>
> I have offered to manufacturer wings, but I have had no offers. My
> wings are off and stripped. It would be an easy do to reverse
> engineer the patterns plus all the blue prints will be a great help.
>
> Any one got an idea what the cost should be?
>
> If any one has the iron parts that would be even better.
>
>
>
> --------------------------------------------------------------------------
------
> Yahoo! Groups Links
>
> a.. To visit your group on the web, go to:
> http://groups.yahoo.com/group/fairchildclub/
>
> b.. To unsubscribe from this group, send an email to:
> fairchildclub-unsubscribe@yahoogroups.com
>
> c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
>
>

'