Fairchild Club Forum

'I have another question. How do I know if the generator I have is a NA-1? The one I'm looking to install is marked as follows: Ranger Engineering Corp. Type 6631, 14 Volt, 12 Amp, RPM 3300, WIND'G Shunt.
There's no NA-1 marking anywhere on it.

Thane'

'Curt,

What generator and voltage regulator are you using on your PT.

Thane

--- In fairchildclub@yahoogroups.com, ptcurt@... wrote:
>
> Cut in on mine is about 1600 rpm, engine that is. Not sure what the generator drive ratio is.
>
> Curt
> Sent via BlackBerry by AT&T ...

'Thanks for the information. I will contact them and see what they have to say.

Regards,
Thane

--- In fairchildclub@yahoogroups.com, "RMR" wrote:
>
> Hi,
>
> I have recently had success with Aerotech in Louisville. It will cost a little more than a NAPA regulator but should last longer ...

'I have a Ranger Engineering Corp generator to install on my PT19B. it's 14 volt, 12 Amp. My question is what voltage regulator should I use? Does the amperage of the regulator matter as long as it is over 12 Amp? I see several on eBay that are in the range of 35 amp.

I think the 12 amps should ...

'Hi guys I've updated my web page stop by and have a look see, upload
any photos or information you would like to share.
Thanks
Thane Riffle
(http://www.riffle-aviation.com)'

'I'm right here.
email: tdragger@comcast.net
webpage: http://www.riffle-aviation.com




--- In fairchildclub@yahoogroups.com, "Steven M. Dennis"
wrote:
> Thane, are you out there?
>
> I would like to get in touch with Thane about purchasing another
one
> of his PT-19 manual CD's ...

'Or you could try ( http://registry.faa.gov/arquery.asp)
Thane






-- In fairchildclub@yahoogroups.com, "rangerrobertmn"
wrote:
> Harry,
>
> You can try www.landings.com. At the bottom of the first page is
a
> section titled SEARCH/REF, then look for DATABASE. It takes a bit ...

'Bob,
There is not an E-gap to set on these mags. They should be set so
that the points just begin to open when the mark on the large gear
aligns with the fixed mark when looking through the timing window.
The best way to accomplish this is to place a .0015 shim stock
between the contacts ...

'Hi John,
Well it kinda depends on the size monitor you are using and the
resolution it's set to. This the first webpage that I have built on
my own, so I'm shure I need to make some adjustments to it. Thanks
for the feed back. This is the kind of stuff I need to know to make
it better ...

'Hello everyone,
I started a poll on my webpage forum concerning my Fairchild PT
Series CD. I would greatly appreciate it if those of you that
purchased it would participate. I'm just looking for some feed back
as to how well you liked it or didn't like it. You can find it at:
(http://www ...