Fairchild Club Forum

'thanks Jamie


--- In fairchildclub@yahoogroups.com, "Jamie S. Treat"
wrote:
>
> I don't have vac pump on any of my birds. I would assume it
would "T" in.
> Will have the engineering here in about a week.
>
> Jamie
>
>
> ----- Original Message -----
> From: "Mike Bourget ...

'thanks

Mike'

'yep,,, was already there when I bought the engine....soooooo using
it to drive the gyros (t&b, AH, DG)

thanks

Mike



--- In fairchildclub@yahoogroups.com, "ranger440c5"
wrote:
> Mike,
> hmmmm.....let's see. You're building a 2/3scale Mustang and you're
> going to mount a vacuum ...

'Hi Jamie,

my air/oil is going in an experimental. question, when you install
yours I assume the big vent (on top of motor mid way to front) goes
to the separator input, the output is obvious and the oil return is
obvious. What is done with the "small vent" (near the vacuum pump)
do you ...

'HI,, has anyone installed one of these,, if so how did you do it. The
separator I have has and inlet, outlet and a "drain" I would figure
the inlet would be fed by the "breather outlet" on the mid top of the
engine. what is done with the "vent pipe" at the back next to
the "vacuum pump ...

'1 cooler is off a Piper PA28 O320 engine,, the other has not been
installed since OH by Pacific... its a stewart warner and looks
identical to the other one.

where could I find the round UAP one?

thanks

Mike

--- In fairchildclub@yahoogroups.com, "ranger440c5"
wrote:
> The ...

'Hi,,, looking to install the oil cooler. I have a yellow tagged and
OH'd cooler from a lycoming setup. Can I use this cooler, or is the
cooler particular to the ranger.

I'm looking in the Ranger instruction book and the schematic mentions
a "thermostatic by-pass valve" and I want to make ...

'Hi all,,, just finished mounting my "original" ranger oil tank on my
project.

oil hoses? any recommendations? using the original "y" pipe and the
original fittings on the tank. soooo would need a "slip on and clamp"
style of hose. The fittings are 1 inch diameter would a 1 inch ID dim ...

'Thanks so much.... as my engine is being installed in a 2/3rd scale
P51, I've had Props Inc of OR make me an 80 inch ground adjustable 4
blade.

thanks again

Mike


--- In fairchildclub@yahoogroups.com, danMichael wrote:
> Mike:
>
> > Hi fellas.... I'm mortified...my prop ...

'Hi fellas.... I'm mortified...my prop manufactorer wants me to confirm
rotation direction (from Pilot seat prosective) on my 440... but all
my manuals and stuff are at the hangar.

So rather than make a mistake,,, I'm asking the question

(walking humbly aware from the computer keyboard ...