Fairchild Club Forum

'Hey Mark, good to hear from you. I ran the engine up on the 24 and
the numbers I was looking for were 250'c cyl.head max at 1500 rpm. I let it
cool to touch and repeated the cycle several times, I think the long steady
flights, an hour to an hour and a half at 2250 rpm, really seated the rings ...

'Do not let it idle, run it up to "high normal" cylinder head temp then shut
it down. Let it cool and repeat this sequence several times then fly it
under load with an eye on the Cyl. head temp. do not let it overheat
continue until the exhaust smoke stops. The oil consumption will be very
high ...

'Me to! But they do work landing. Bob

-----Original Message-----
From: rangerrobertmn [mailto:rangerrobertmn@yahoo.com]
Sent: Thursday, January 13, 2005 6:40 PM
To: fairchildclub@yahoogroups.com
Subject: [fairchildclub] Re: NACA report on split flaps



Bob Haas,
Note that the NACA ...

'Hey Jamie! We all know that the '46 24's land better with full flaps on hard
surface, what is the message we have all missed? Bob.

-----Original Message-----
From: Jamie S. Treat [mailto:jamietreat@direcway.com]
Sent: Wednesday, January 12, 2005 6:54 PM
To: fairchildclub@yahoogroups.com ...

'Good morning everyone, several months ago there was a discussion
about shipping a Fairchild 24 overseas in a container.

Does any one remember the details, primarily will it fit? Any information
would be appreciated. Bob Haas NC 81236, which is still for

sale.



[Non-text portions of ...

'-----Original Message-----
From: Michael Denest [mailto:mjd12k@yahoo.com]
Sent: Monday, December 27, 2004 12:18 PM
To: fairchildclub@yahoogroups.com
Subject: [fairchildclub] For Bob Haas



Hi Bob,
I'm going to be in the Ft. Myers area (Sanibel Island)
this week to celebrate the New Year ...

'Hi Bob I probably have them used but serviceable, I'll look if you are
interested. Bob Haas 239 694 2875

-----Original Message-----
From: rangerrobertmn [mailto:rangerrobertmn@yahoo.com]
Sent: Tuesday, December 14, 2004 11:04 PM
To: fairchildclub@yahoogroups.com
Subject: [fairchildclub ...

'Hey Bob! You have been reading my book, I have been practicing those
procedures for years. I'm still flying the 19 and the 24 here sunny Fl.
Bob Haas.

-----Original Message-----
From: BOB DUNN [mailto:bobaviator@yahoo.com]
Sent: Monday, December 06, 2004 10:20 PM
To: fairchildclub ...

'I have been using AUA for three years with out any surprises, Bob Kamsch, at
1800 727 3823. Get a quote.

-----Original Message-----
From: Alan Macon [mailto:macon5@charter.net]
Sent: Monday, December 06, 2004 1:21 PM
To: fairchildclub@yahoogroups.com
Subject: [fairchildclub] Insurance ...

'I believe the bushings can be fabricated from standard stock
purchased at a bearing supply store. Take the shaft and see if they can
match the ID then cut it to fit and paint to match.

-----Original Message-----
From: m77mb [mailto:m77mb@yahoo.com]
Sent: Wednesday, November 17, 2004 6:28 PM ...